• The primary benefit offered by drywall screws is their Bugle Head. This means that the entire screw lies flush with the surface of the sheet, creating a smooth and even finish.
• Less prone to getting pulled through the wood due to Bugle Head.
• This type of head also helps prevent the drywall screw from breaking the paper surface, a common problem with nails.
• Drives fast and efficient.
• The black head adds to the decorative appeal.
• Fairly thin, so they are less likely to split the wood.
• Threaded through entire length thereby maximizing gripping power.
• Good Corrosion resistance due to black phosphate coating.
• Easy to install and remove.
• Head does not sink into the wood easily as does with other wood screws.
• Precise cutting edges to improve drill performance with less effort.
• Relatively Cheap.
• At least 3 times the pull-out strength of nails.

• Original and primary application is to stitch Drywall to wood studs. Also used in many interior wood and fixture fastening applications.
• Used to rapidly attach drywall to metal studs for commercial buildings.
• Used where flat surface required after drill.
• Used where already pre-drilled holes are prepared for fitting.

How to Install :

• For the specified anchor size, select carbide or core drill bit with nominal diameter as listed below in Table.
• Drill hole to depth listed below.
• Essentially clean holes with brush and blower.
• Remove debris with hole cleaning pump, compressed air or with a brush.
• If the holes are wet or flooded, clean hole with brush.
• Insert Capsule into hole.
• Spin in Welfast Stud as per required anchorage depth using a rotary hammer drill.
• Allow adhesive to cure for the time as listed below.
• When cured, tighten nut applying the necessary tightening torque.

Suitable for :

• Concrete
• Dense Natural Stone